ssWindow Glass Replacement

When replacing a shattered single-glazed window, installing new glass safely and making straight glazing lines can be intricate. The windowpane will determine your approach. A wood frame requires more work to repair but retains the historic charm of your home. A new home is more likely to have vinyl frames that are easier to deal with.

Only a professional can trim double-glazed windowpanes.

Usually, a nearby hardware store for window glass replacement Macedon Ranges or glass specialist can cut the glass for you. Unless the pane is tiny, use a double-thick glass.

Order shatter-resistant glass for doors and sidelights if possible.

·        Handling shattered glass necessitates the use of thick gloves, long clothing, and protective eyewear.

·        Tiny splinters can be dangerous.

·        Use a putty knife and standard glazing putty to seal the glass.

·        When applying glazing putty with a knife, you get a stronger bond and a smoother surface.

·        Double-glazed panes usually necessitate the installation of new sealing tape.

·        Rubber gaskets in good condition can be reused.

·        Caulking needs to be scrapped and replaced.

·        Wood moulding can be reused in most cases, but it can also be replaced.

·        The steps below will show you how to install and seal glass in all window frames properly.

The first step is to remove any glass shards.

While it is possible to replace glass while the sash is still in the frame, removing the structure and working on a table is preferable. Wearing protective clothing, wiggle and pull out the pieces of glass. You may need to tap the glass with a hammer first to create a new break line. Apply a grid of duct tape to the pane if the glass does not simply pull out in sections. Using a heat gun and a scraper or chisel, remove all of the putty and points, then remove the window in one piece.

The second step is to remove the putty and glaze.

Carefully remove all glass, putty, and metal glazing points. You can use an old chisel or a paint scraper with a pull-type. If you're going to use a hammer, be gentle with it. The grooves into which the new window will be installed must be completely smooth. A heat gun can be used to soften the old putty. Pry out any wood moulding that is holding a window in place with a flat pry bar. Scrape away any old silicone caulk, reapply, and test the fit. The pane of glass should be pressed into the caulk. Make sure the nails are angled away from the glass when reinstalling the wood moulding.

3rd STEP - Framework for Preparation

After wire-brushing, vacuum or wipe the frame with a slightly damp rag. Apply linseed oil to the rabbet to help the putty stick to the surface.

4th STEP - Measurement Pane

Carefully measure the height and width of the entrance at least twice. Order a piece of glass that is 1/8 inch shorter in each direction. Check that the glass fits appropriately before proceeding.

Putty should be used in the fifth step.

Create a thin rope from a ball of glazing compound. It should be pressed into the corner of the rabbet. Then, press it firmly into place using a putty knife, creating a thin bed of putty for the glass to rest on.

6th STEP - Examine the glasses

Make sure the glass is completely flat against the rabbet by pressing it into the putty bed. Every 6 inches, gently press a glazing point into the wood against the glass.

STEP 7 - Putty in a Roll

Make a 3/4-inch thick putty rope. Aim for a consistent diameter, but don't worry if it's not perfect.

EIGHTH STEP - Apply Putty to Glass

Press the rope against the glass and the frame with your thumb. Apply linseed oil to a glazier's or putty knife repeatedly, swiping motions every inch or two.

STEP 9 - Make a Smooth Putty

Press firmly and draw the knife along the line to smooth the putty while working in the same direction and holding the blade at the correct angle, so the putty is not visible inside.