So they'll help hold it in place but if you still cannot maneuver the window around enough to get to the bolt to release the window from the regulator and this is what's going on with this vehicle right now this is when it's really nice to have one of these ratcheting wrenches you can sneak it behind the door here and get on that ten millimeter bolt and loosen it up and remove the window from the regulator once you've got the glass loose it just slides right out disconnect the wiring from the old motor and finally out comes the old regulator and as you can see it was the cable began to unravel itself as you can see here on the track and it's almost completely broken down in here that's why the Car Window Tint Near Me was no longer going up.
And down now the installation procedure is pretty much the opposite of what you did to get the old one out don't forget to take your three screws that you left behind on the old motor and regulator and thread them back into the same openings on the motor end regulator to hold it in place during the reinstallation then install the remaining bolts onto the regulator and the motor once you've got all the bolts started go ahead and tighten them up by hand you want to make sure that initially you're only putting them in loosely so you can move the regulator around and adjust it as needed but once it's all lined up tighten them down don't forget to plug the connector into the motor most new window regulators as you see in this case right here have the holes for the window glass lined up with the holes in the door panel to tighten them up but if they're not you can always plug in the window switches on the door panel and adjust the regulator accordingly to get it to line up now because of all the grease from the regulator.
And the cables and everything getting the window out as you can see in the light here you're probably gonna have a lot of dirt grease and fingerprints on the Vehicle Window Tint Near Me it's a good idea to clean this before you put it back in the car and the reason being is if you put it back in now any grease is going to get on the window seals and as the window moves up and down that grease is going to get in those seals and then every time you open and close the window it's going to recoat the glass with grease so before you put this window back in the car take some cleaner and clean the glass up to make it nice and pretty get all that grease off then very carefully reinstall the glass once the glass is installed you'll see that the regulator lines up with the little holes down here all you have to do is take your two ten millimeter screws which you took out earlier Andry secure the window to the regulator most of the times you can reuse a weather seal.
