Sachiya Steel International is one of the Leading Manufacturer And Exporter Of High-Quality Stainless Steel 410 Wire Mesh, which have austenite as their primary phase (face-centered cubic crystal). SS 410 Hexagonal Wire Mesh is used for a variety of applications where good corrosion and outstanding hardness are necessary. Stainless Steel 410 Welding Wire Mesh also offers higher creep, stress to rupture, and tensile strength at elevated temperatures, in addition to excellent corrosion resistance and strength properties.
Sachiya Steel International is one of the prominent supplier and manufacturer of Stainless Steel 410 Wire Mesh, which have austenite as their primary phase (face centered cubic crystal).
SS 410 Hexagonal Wire Mesh is used for a variety of applications where good corrosion and outstanding hardness is necessary.
Stainless Steel 410 Welding Wire Mesh also offers higher creep, stress to rupture and tensile strength at elevated temperatures, in addition to excellent corrosion resistance and strength properties.
Stainless Steel 410 Netting Wire Mesh contains chromium and nickel (sometimes manganese and nitrogen), structured around the composition of iron, 18 % chromium, and 8 % nickel.Austenitic SS 410 Woven Wire Mesh are not harden able by heat treatment, which further refer to the lower carbon content to allow for greater corrosion protection when welding.
Stainless Steel 410 Spring Steel Wire Mesh is austenitic steel containing 18 % – 20% chromium and 8 % – 10% nickel.
SS 410 Fencing Wire Mesh is not subject to embrittlement or loss of corrosion resistance in the heat – affected zones that affects many other straight chromium alloys.
Sachiya Steel International is one of the Leading Manufacturer And Exporter of Stainless Steel 410 Flanges, where better finishes are obtained in the cold drawn or heat – treated condition.
In its softest condition, these Stainless Steel 410 Slip On Flanges is tough and chips build up on tools.
If higher mechanical properties are required, our Stainless Steel 410 Threaded Flanges can be machined.
Our Stainless Steel 410 Weld Neck Flanges are low carbon steels built around the composition of iron, 12 % chromium, and 0.12 % carbon.
These Stainless Steel 410 Blind Flanges provides good corrosion resistance to air, water and some chemicals, where resistance to food acids is good.Our Stainless Steel UNS S41000 Socket Weld Flanges shows satisfactory resistance to nitric acid, concentrated sulphuric acid, dilute acetic acid and naphtha.
These Stainless Steel 410 Lap Joint Flanges has extensive use in aircraft parts, such as exhaust systems where operating temperatures are higher than 800 Degree F and where corrosive conditions are not too severe; also for the reason that of its resistance to scaling and vibration fatigue.Stainless Steel 410 Flanges | Stainless Steel 410 Flanges | Stainless Steel 410 Flanges | Stainless Steel 410 Flanges | Stainless Steel 410 Flanges | Stainless Steel 410 Flanges | Stainless Steel 410 FlangesOur Stainless Steel 410 Ring Joint Type Flanges may be tempered and hardened, which gives steel great hardness, but also reduces its toughness and makes it brittle, so few steels are fully hardened.
