If you’re wondering whether you can repair the Cardan shaft or driveshaft of your vehicle, then this topic is for you. It’s perfectly possible to fix the driveshaft of a car. Some DIY fanatics never like professional mechanics messing around with their automobiles. Folks like these only need the most commonly used garage tools and a few Spare Parts for Cardan Shafts to get their vehicles moving again. By following the guidelines elucidated below, you can achieve the desired results.
- Unbolting the bolts: The first step incorporates unbolting the bolts holding the driveshaft in its place. Once you remove the bolts, you can displace the driveshaft to start the repair work. In most instances, four bolts on each side hold the driveshaft where it needs to be. After removing the driveshaft, you have to turn your attention towards the universal joint or U-joint.
- Removing the U-joint: As mentioned above, the second stage involves removing the universal joint or U-joint from the driveshaft. However, before you attempt to work on the U-joint, you have to dislodge the retaining clips holding the U-joint to the driveshaft. Just as the driveshaft has four bolts on each side holding it in place, the U-joint has four retaining clips doing the same thing.
- Applying pressure: Now you have to apply pressure to the U-joint to loosen it up. Then, you have to remove the U-joint from the driveshaft. This process is the only one that requires an exclusive press tool. Without it, you may experience problems pressing the U-joint downward. Unless you can acquire this tool, consider delegating the task of repairing to professional service providers.
- Removing the bearing cap: Once the universal joint is out of the way, you have to work on the bearing cap. You’ll need to remove it from the U-joint. Finally, you must repeat the process for the rest of the bearings.
- Placing the new ones: The fifth step of the process involves getting rid of the old universal joints and replacing them with new ones purchased from the dealers of Spare Parts for Cardan Shafts. Before you do that, though, you must prepare the flange and driveshaft by cleaning the debris from the old parts.
- Reversing the whole process: In the end, you have to retrace your steps to reinstall all the components you removed. Just remember to apply grease to the U-joint to ensure it doesn’t get affected by the elements of nature.
Cost of repairing
The cost of repairing the Cardan shaft or driveshaft of a vehicle or industrial machinery shouldn’t be too much. It’s especially true for people who are handy with a toolbox. If you’re at using handheld tools, you can complete the process without outside intervention. It’ll also allow you to reduce your expenses significantly. In the USA, U-joints are as cheap as $25. Repair shops charge around $50 and $100/hour, but if you follow the steps given here, you can avoid spending even a penny more than you need to.
Tradelink Services offer Samiflex elastic couplings.
Samiflex elastic couplings are available in 16 models to transmit power from 2 Nm to 3,670 Nm and bore range upto 210 mm.Website:http://www.tradelinkservices.in/elastic-couplings.php
