1. Keep the servo motor away from oil and water
A: The servo motor can be used in places that are affected by water or oil droplets, but it is not completely waterproof or oil-proof. Therefore, the servo motor should not be placed or used in an environment flooded with water or oil.
B: If the servo motor is connected to a reduction gear, an oil seal should be used when using the servo motor to prevent the oil from the reduction gear from entering the servo motor.
C: Do not immerse the servo motor cable in oil or water.
2. Servo motor cable
A: Ensure that the cable is not subject to moments or vertical loads due to external bending forces or its own weight, especially at cable exits or connections.
B: When the servo motor is moving, the cable (the one configured with the motor) should be firmly fixed to a stationary part (relative to the motor) and should be extended with an additional cable installed in the cable holder. it, so that bending stress can be minimized.
C: Make the bend radius of the cable as large as possible.
3. Allowable shaft end load of servo motor
A: Make sure that the radial and axial loads added to the servo motor shaft during installation and operation are controlled within the specified values of each model.
B: Be extremely careful when installing a rigid coupling, especially as excessive bending loads may cause damage or wear to the shaft end and bearings.
C: It is best to use a flexible coupling to keep the radial load below the allowable value. This coupling is specially designed for servo motors with high mechanical strength.
4. Notes on servo motor installation
A: When installing/disassembling the coupling component to the servo motor shaft end, do not directly hit the shaft end with a hammer. (If the hammer hits the shaft end directly, the encoder on the other end of the servo motor shaft will be damaged)
B: Try your best to align the shaft end to the best state (if done incorrectly, it may cause vibration or bearing damage).
Accurate Technology is a leading supplier of Servo Drives and renders on-call repair service of all major AC and DC Servo Motors, Drives and controllers.
Servo motors and drive repair process require extreme caution and adequate care should be taken prior to conducting any disassembly of servo motor or servo drive service unit.
At accurate technology we make it a point to always record the important aspects of the equipment like the Manufacturer, Serial number, complaint or problems, the expected time for service, urgency etc.
Whenever a servo drive fails, the industrial operations come to a grinding halt.
You need to put them back in good fettle at the earliest to minimize loss of production etc.
Our battery of technicians has the expertise and wherewithal to quickly identify even the toughest problems and repair them in a jiffy.
Providing quality Hitachi VFDs, AC Drive, Dc Drive, Servo Motor, Servo Drive, PLC repair for industries throughout the India, UPT Services can take care of your problem and get your unit running like new again.
SMD Hollow rotary Gearbox is mainly used in Indexing Table and in Rotary Table thus it is also called Indexing Gearbox and Rotary Table Gearbox.
SMD Hollow rotary Indexer has large hollow rotary table for concise wiring and piping and also has maximum backlash on 30 Arc Seconds.
Hollow bore driven by client’s servo motor via large helical ring gear integrated in a rotating flange provides smooth, accurate and fast positioning & indexing.
The Experienced Technocrats in SMD are in proper contact with the clients to understand the requirement properly and suggests a proper solution which increases the efficiency of the client.
SMD Gearbox are widely used in Automation, Automobile, Pharmaceutical, Aerospace, Engineering, Medical, Agriculture, Machine tool, etc.
For More Information Visit,Website - https://www.smdgearbox.com/hollow-rotary-gearboxImgur Reference - https://imgur.com/gallery/ukEAIWCContact - +886 (09) 67388376 / +91 7030669818Mail id – [email protected]
