What Can Lead To Brake Failure?

Our car is a structure of complex machinery. It won’t be wrong to call it a true marvel of engineering. All its components work in tow to make the system work efficiently. Even if one thing goes wrong in the car, it won’t be surprising to see other systems also going haywire. That’s because they are all connected. 

Out of so many components of your vehicle, brakes also play a crucial role in providing you with a safe and secure drive. They are the ones who bring your car to a halt. They save you from several mishaps. Failure of this part can lead you to catastrophic accidents. So, it’s extremely important that know the reasons for brake repair Birmingham failure so that you can rectify them on time. There’s no way you can ignore them. 

How do brakes work?

Brakes convert the energy into heat by using the force of friction. A lever that’s connected there pushes the piston into the master cylinder. This cylinder is filled with hydraulic fluid, which helps in stopping the car.

Leaking of this fluid can hinder the functioning of the brakes, and this needs to be checked immediately time to know some major reasons for brake failure. 

Why do my brakes fail?

Brake pads overheating

When we use our brakes excessively, they get hard or brittle over the period. As a result, the pads lose the grip over the wheel rotor disk, and this leads to a larger braking distance. 

Air pressure not enough

If the brake pedal pushes down to the floor, then that is an indication of low air pressure. You must avoid driving your vehicle at this point, as it can lead to some serious accidents. 

Hydraulic fluid oozing out

At times, hydraulic fluid or oil may leak out from the engine of your car or the brake repair Birmingham lines. This will hamper the stopping of your car. You might want to get checked your car for some contamination in the line. 

Grease on the brakes

The oil or grease on the brakes interferes with the friction used on them. At times, the oil leaks from the oil seal. This also hampers the functioning of the brakes.

Squealing sound from the brakes

As brake pads get thin, they may start squealing too. This shows they are completely worn down and have reached the rotor disk. This might cost you a big amount in replacing them. 

Vehicle overloading

That’s a very common reason for brake failure. It’s quite natural that overloading will impede the stopping of your vehicle. The owner’s manual states the amount of load your car can carry, and you must follow it stringently. 

Corrosion in some parts 

Cast iron used to make the brakes can rust quickly. If unattended, this rusting can worsen and can even cause the surface to pit. 

Delay in replacing the discs and pads

The front discs wear out with time and become quite thin. The manufacturer always specifies with instructions when to replace the discs and the pads. You must replace them when advised. 

Some common signals for the brake failure

A thorough inspection of the brakes and pads is advised annually. Change the brake fluid once every four years or when your car hits miles close to 50,000. 

• There’s a light in the antilock brake system (ABS), which will flash on. This is a signal of brake not working well. 
• You feel your car drags when you accelerate it.
• When you feel the pedal pulsing as you apply the brakes.
• You hear some squeaking or grinding sound as you apply the brake. 
• You feel your car pulling towards one side. 

Brakes are extremely important to be always working properly. If you see any of the above signs, you must take your go for car service Birmingham immediately to avoid any tragic incident later.